Surface treatment | Anti-static / Anti-skid , Glossy/shiny or dull | Description ( L× W ) | 10mx1.2m,10mx1.0m,10mx0.9m,10mx0.6m | Color (Top/Bottom) | Green/Green, Green/Blue, Green/Gray,Green/Black | Thickness | 2.0mm, 3.0mm | Above sizes are standard, customized size available.(length, width, thickness, color, etc are optional). Can also be tailor-made to sample! The company's anti-static rubber sheet (table mat, mat) using 100% high quality rubber. Anti-Static Table Mat Application: ESD Table Mat (ESD Rubber Sheet) is mainly used in manufacturing shop and senior laboratory of electronic industry, such as electronic semiconductor, device electronic computer, electronic communication devices and integrated circuits, etc. The mat is used for table, goods shift and ground mat. And it can be used in different environment. Method for laying dissipative table mat Lay the dissipative mat on the table, connect the button of the antistatic grounding line on the surface and connect the other end to the grounding conductor, to discharge the static electricity through the grounding wire. 1. The upper surface is to gather the static electricity around the table, with the resistance of 10e6- 10e9 Ωcm; 2. The black bottom is a conductor ≤106Ωcm, to quickly discharge the gathered static electricity; 3. The grounding wire is to connected with the dissipative mat and the other end to the ground, to smoothly discharge the static electricity through the wire. Method for laying dissipative floor mat 1. Requirements on floor A) The floor shall be the wet rubbing, ceramic or wooden floor; B) It shall be flat, without obvious undulation, and with the roughness less than 2‰; C) It shall be in enough strength, without sand streak or scaling. D) The floor shall be dry. 2. Construction procedures and methods A) Clean the floor with #120 gasoline or xylene (with cleaning machine); B)Lay the copper bars or aluminum bars, when the copper bars are 0.02mm thick and 30mm wide, the length and number shall be subject to the actual requirements during laying, and lead one end of the copper bars to ground. C) After laying the grounding grid, clean the dry floor, coat the conductive glue, and allow it to dry for 20 – 30 minutes until it is not sticky. Repeat the same procedures for the bottom of the antistatic floor mat (black), but coat the conductive glue once. Then bind the antistatic plastic on the floor, roll 5 times with heavy roller, to make it flat and smooth. Allow it to stay for 48 hours under normal temperature before use. D) Construct under the ambient temperature not less than 25°C and the humidity not more than45%, and well ventilated. E) Ensure the resistivity of conductive glue not more than 10e8Ωcm, and the anti-stripping strength at Kg/2.5cm. F) Coat the conductive glue or paste on the copper bar for conductivity in the gaps. If you have any questions, please feel free to contact us. Contact us if you need more details on Antistatic Rubber Sheet. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Antistatic Esd Rubber Sheet、Antistatic Rubber Sheet. If these products fail to match your need, please contact us and we would like to provide relevant information. Product Categories : Anti-static rubber sheet
|